Hisense GSNF 235 Benutzer-Bedienungsanleitung Seite 130

4.Lever handle covers ① and loose
screws ② , remove the handle ③ as
show f igure Ⅰ ,then place it at side
for use. Take the screw hole covers ④
down as show f igure Ⅱ , and install
them in the right side as show f igure
Ⅲ . Change handle to left, install it as
show f igure Ⅳ . Detach door stopper
⑤ and limit block ⑥ and then install
door stopper and limit block to right as
show f igure Ⅴ and Ⅵ .
Ⅰ
③ ② ①
Ⅲ
Ⅴ
⑤
⑥
⑦
① Handle covers ② Screws
③ Handle ④ Screw hole covers
⑤ Door stopper ⑥ Limit block
⑦ Self-tapping screws
5. Place refrigerator flatwise, remove
and then loose screws④ .
part③
Remove part ② and part① as the
picture .
①
②
③
④
① Left Lower hinge part
③ Adjustable bottom feet part ④ special flange self-tapping screw
6. Screw out lower hinge axis, change
it to the near hole site as the picture
below, and then screw up and mount
washer as the picture below.
Note: washer may
stick to the door.
Ⅱ
④
Ⅳ
Ⅵ
② Front foot fixed board
washer
hinge axis
7.Just remount to the step 5,change
part① to right and part② to left and
then fix them with screws④ . Finally
install part③.
8. Take off the part ①, place it at side
for use as show figure Ⅰ . Move the
freezer door to appropriate position,
adjust part ② and door, then fix part
by screws as show f igure Ⅱ .
②
(Please hold upper door by hand when
installing). Fix the part ③ as show
f igure Ⅱ (which is in the plastic bag) .
Reverse part ① by 180°and install it
onto the left corner of the door as
show f igure Ⅲ . Finally mount part ④
as show f igure Ⅳ. ( which was taken
down in step 2)
Ⅰ
Ⅱ
①
Ⅲ
9.Finally install part ① and part ②
(both of which are taken down in step
2) in the refrigerator body as the
picture below.
①
②
③
Ⅳ
④
②