Installing The Filter Cartridge; Refrigerator Doors; Water Filter - General Electric Side-by-Side 21 Bedienungsanleitung Und Installation

About the water filter.
Cartridge
Holder
Place the top of the cartridge up
inside the cartridge holder and
slowly turn it to the right.
About the refrigerator doors.
When the door is only partially
open it will automatically close.
Beyond this stop the door will
stay open.
Water Filter Cartridge
The water filter cartridge is located in the back upper
right corner of the refrigerator compartment.
When to Replace the Filter
LCD Models:
A pop-up screen will appear on the LCD screen
to remind you to replace the water filter. You can
check the status of the water filter manually.
Access By: Home > Options > Dispenser Options >
Reset Water Filter
Non-LCD Models/External Controls:
There is a replacement indicator light for the water
filter cartridge on the dispenser. This light will turn
orange to tell you that you need to replace
the filter soon.
The filter cartridge should be replaced when the
replacement indicator light turns red or if the flow
of water to the dispenser or icemaker decreases.
Removing the Filter Cartridge
If you are replacing the cartridge, first remove the old
one by slowly turning it to the left. Do not pull down on
the cartridge. A small amount of water may drip down.

Installing the Filter Cartridge

There is an adapter attached to the top
of the new filter cartridge.
The adapter must be removed before installing
the cartridge. To remove the adapter, turn it to
the left about 1/4 turn.

Refrigerator Doors

The refrigerator doors may feel different than
the ones you are used to. The special door
opening/closing feature makes sure the doors
close all the way and are securely sealed.
When opening and closing the door you will
notice a stop position. If the door is opened
past this stop point, the door will remain open
to allow you to load and unload food more easily.
When the door is only partially open, it will
automatically close.
The resistance you feel at the stop position will
be reduced as the door is loaded with food.
Fill the replacement cartridge with water
from the tap to allow for better flow from
the dispenser immediately after installation.
Line up the arrow on the cartridge and
the cartridge holder. Place the top of the new
cartridge up inside the holder. Do not push
it up into the holder.
Slowly turn it to the right until the filter cartridge
stops. DO NOT OVERTIGHTEN. As you turn
the cartridge, it will automatically raise itself into
position. The cartridge will rotate about 1/2 turn.
Run water from the dispenser for 5 minutes
to clear the system and prevent sputtering.
LCD Models:
Press FILTER REPLACED button to confirm
replacement.
Non-LCD Models:
Press the SET FEATURES pad until REPLACE
WATER FILTER is lit. Press and hold the ON/OFF
pad for 3 seconds. WATER FILTER IS RESET will
show in the window.
NOTE: A newly installed water filter cartridge may
cause water to spurt from the dispenser.
Filter Bypass Plug
You must use the filter bypass plug when a
replacement filter cartridge is not available.
The dispenser and the icemaker will not operate
without the filter or filter bypass plug.
Replacement Filters:
To order additional filter cartridges, contact your
local distributor.
9