How To Use; Customcool - General Electric Side-by-Side 21 Bedienungsanleitung Und Installation

About CustomCool
LCD Models Only
ExpressThaw
™
ExpressChill
™
.
™
(on some models)
Non-LCD Models Only
How it Works
The CustomCool feature is used to quickly chill
™
items, thaw items or hold the pan at a specific
temperature. This feature is a system of dampers,
a fan, a temperature thermistor and a heater.

How to Use

Empty the pan. Place the Chill/Thaw tray
in the pan. Place the items on the tray
and close the pan completely.
LCD Models:
Access by: Home > Options > Refrigerator
Options > CustomCool Pan
Non-LCD Models:
Select the ExpressThaw
or SelectTemp pad. The display and SET light
™
will come on. Tap the pad until the light
appears next to the desired setting.
Use the following chart to determine the best
setting to use.
ExpressChill can be set to 15, 30 or 45
minutes. The default is 15 minutes.
To stop a feature before it is finished:
For LCD Models:
Go into that feature's menu and press
the OFF button.
How to Remove and Replace the Drawer
To remove:
Pull the drawer out to the stop position.
Rotate all four swing locks to the unlock
position.
Lift the front of the drawer up and out.
To replace:
Make sure all four swing locks are
in the unlock position.
Place the sides of the drawer into
the drawer supports, making sure
the swing locks fit on the drawer slots.
OR
The pan is tightly sealed to prevent
temperature fluctuations in the rest of
the refrigerator. The controls for this pan
are located on the dispenser with the
temperature controls.
, ExpressChill
™ ™
NOTE: For food safety reasons, it is recommended
that foods be wrapped in plastic wrap when using
ExpressThaw. This will help contain meat juices
and improve thawing performance.
R O
EFRIGERATOR PTIONS
C C
USTOM OOL
T
URBO
P
AN
B
EVERAGE
C
ENTER
B
ACK
LCD Models Only
For Non-LCD Models:
Tap that feature's pad until no options
are selected and the display is off.
During ExpressThaw and ExpressChill,
the display on the controls will count down
the time in the cycle (on some models).
After the ExpressThaw cycle is complete,
the pan will reset to the MEAT setting
(32°F [0°C]) to help preserve thawed
items until they are used.
The displayed actual temperature of
the CustomCool pan may vary slightly
from the SET temperature based on
usage and operating environment.
Lock all four swing locks by rotating them
to the lock position.
C
OOL
7