Installation Instructions - General Electric Side-by-Side 21 Bedienungsanleitung Und Installation

Installation
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
local inspector's use.
IMPORTANT –
•
codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
•
Skill level – Installation of this appliance requires
basic mechanical skills.
•
Completion time – Refrigerator Installation
15 minutes.
•
Proper installation is the responsibility of the installer.
•
Product failure due to improper installation is not
covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
)
(ON SOME MODELS
If the refrigerator has an icemaker, it will have
to be connected to a cold water line. An approved
water supply kit is available at extra cost from your
local distributor.
Maximum permissible inlet water pressure–8.2 bars.
Minimum permissible inlet water pressure–2.8 bars.
Installation of the icemaker must be done by a qualified
service technician.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 16°C because it will not run often enough
to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 37°C because it will not perform properly.
• Install it on a floor strong enough to support it fully
loaded.
Save these instructions for
Observe all governing
Be sure to leave these
Keep these instructions
Refrigerator
Models 21, 23, 25, 27 & 29
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical connections:
21' and 23' and
25' Custom Style
• Sides 3 mm
• Top 25 mm
• Back 25 mm
DIMENSIONS
21 23BIS
A* 1766 mm 1766 mm 1766 mm 1766 mm
B 912 mm 912 mm
C 607 mm 607 mm
D 680 mm 680 mm
E** 750 mm 750 mm
F 1160 mm 1160 mm 1270 mm 1272 mm 1262 mm 1169 mm
G 909 mm 909 mm 909 mm
H** 985 mm 985 mm
*Height to top of hinge
**Includes handle
A
A
B
B
25
25', 27' and 29'
3 mm
25 mm
25 mm
25 27 29
1766 mm
916 mm 912 mm 912 mm
712mm 712 mm 712 mm
790 mm 794 mm 825 mm 689 mm
886 mm 860 mm 916 mm 753 mm
909 mm 909 mm 909 mm
1013 mm 982 mm 1048 mm 970 mm
C D E
G
H
25BIS
1832 mm
912mm
607 mm
F