Automatic Icemaker - General Electric Side-by-Side 21 Bedienungsanleitung Und Installation

About the automatic icemaker.
A newly-installed refrigerator may take 12 to 24 hours to begin making ice.
Power
Switch
Icemaker
Green
Feeler Arm
Power Light
Shelf
Ice Drawer
Pull the upper freezer shelf straight
out to access the icemaker. Always
be sure to replace the shelf. The
shelf can be used for storage.
NOTE: In 25BIS Models, the ice bin
is suitable for the storage of ice
only.
Ice Drawer

Automatic Icemaker

The icemaker will produce seven cubes
per cycle–approximately 100–130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room temperature,
number of door openings and other use
conditions.
To access the icemaker: Pull the shelf above
the ice drawer straight out. Always be sure
to replace the shelf.
If the refrigerator is operated before the water
connection is made to the icemaker, set the
power switch in the O position.
When the refrigerator has been connected
to the water supply, set the power switch
to the l position.
You will hear a buzzing sound each time
the icemaker fills with water.
The icemaker will fill with water when it cools
to – 10°C. A newly-installed refrigerator may take
12 to 24 hours to begin making ice cubes.
Throw away the first few batches of ice to allow
the water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler arm,
the icemaker will stop producing ice. It is normal
for several cubes to be joined together. If ice is
not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
If ice cubes get stuck in the icemaker, the green
power light will blink. To correct this, set the
power switch to O and remove the cubes.
Set the power switch to I to restart the icemaker.
After the icemaker has been turned on again,
there will be a delay of about 45 minutes before
the icemaker resumes operation.
NOTE: In homes with lower-than-average water
pressure, you may hear the icemaker cycle
multiple times when making one batch of ice.
Ice Storage Drawer
To access ice, pull the drawer forward.
To remove:
Set the icemaker power switch to the O (off)
position. Pull the drawer straight out and
then lift past the stop position.
To replace:
When replacing the drawer, be sure to press
it firmly into place. If it does not go all the way
back, remove it and rotate the drive mechanism
1/4 turn. Then push the drawer back again.
WARNING:
water supply only. Installation of the icemaker
must be done by a qualified service technician.
Special note about ClimateKeeper2
models:
Dispenser models have a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and it will hold itself up while
you take ice out or turn the icemaker power
switch on and off. Be sure to put the bin back
in place before closing the door.
To restore your ice level from an empty bucket
stage, the following steps are recommended:
12 hours after the first batch of ice has fallen
into the bin, dispense 3 to 4 cubes.
After an additional 6 hours, dispense 3 to 4
cubes again.
These steps will restore your ice level
in the shortest amount of time.
On dispenser models with a tilt-out ice bin, to
access ice or reach the power switch:
Lift the bin, then pull it forward until the bin stops.
Lower the bin to access ice or reach the power
switch.
NOTE: In order to take full advantage of the tilt-out ice bin,
only store items on the shelf below the ice bin that are no
taller than the lowest point on the bin.
Rotate
Drive
Mechanism
Connect to potable
dispenser
™
15