Crispers And Pans - General Electric Side-by-Side 21 Bedienungsanleitung Und Installation

About the crispers and pans.
Not all features are on all models.
About crisper removal.
Not all features are on all models.
14
Fruit and Vegetable Crispers
Excess water that may accumulate in the bottom
of the drawers should be wiped dry.
On some models the bottom drawer has
a cover that slides back as the drawer is opened.
This allows full access to the drawer. As the
drawer is closed, the cover will slide forward
into its original position.
Adjustable Humidity Crispers
Slide the control all the way to the
(high) setting to provide high humidity
recommended for most vegetables.
Convertible Meat Pan
The convertible meat pan has its own cold air
duct to allow a stream of cold air from the freezer
compartment to flow to the pan.
The variable temperature control regulates
the air flow from the Climate Keeper.
Crisper Removal
The top crispers can easily be removed by pulling
the drawer straight out and lifting the drawer
up and over the stop location.
If the door prevents you from taking out the
drawers, first try to remove the door bins.
If this does not offer enough clearance, the
refrigerator will need to be rolled forward until
the door opens enough to slide the drawers out.
In some cases, when you roll the refrigerator out,
you will need to move the refrigerator to the left
or right as you roll it out.
To remove the bottom crisper:
Pull the drawer out to the stop position.
Rotate all four swing locks to the unlock
position.
Lift the front of the drawer up and out.
Slide the control all the way to the
setting to provide lower humidity levels
recommended for most fruits.
Set the control to the
to store fresh meats.
Set the control to
the pan to normal refrigerator temperature
™ and provide extra vegetable storage space.
The cold air duct is turned off. Variable settings
between these extremes can be selected.
To replace the bottom crisper:
Make sure all four swing locks are
in the unlock position.
Place the sides of the drawer into the drawer
supports, making sure the swing locks fit
on the drawer slots.
Lock all four swing locks by rotating them
to the lock position.
(low)
(coldest) setting
(cold) to convert