Options; Before First Use - Electrolux GA60KVSW Benutzerhandbuch

the indicators
to flash and the display is blank.
2. Press
• The indicators
off.
• The indicator
flash.

7. OPTIONS

Desired options must be
activated every time before
you start a programme
(except for Multitab).
It is not possible to activate or
deactivate options while a
programme is running.
7.1 XtraDry
Activate this option when you want to
boost the drying performance. With the
use of this option, the duration of some
programmes, water consumption and the
last rinse temperature can be affected.
The option XtraDry is not a permanent
option and must be selected at every
cycle.
How to activate XtraDry
Press .
The related indicator comes on.
If the option is not applicable to the
programme, the related indicator does not

8. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
, , and start
, and go
continues to
• The display shows the current
setting:
3. Press to change the setting.
= Acoustic signal on.
4. Press the on/off button to confirm the
setting.
come on or it flashes quickly for a few
seconds and then goes off.
The display shows the updated
programme duration.
7.2 TimeSaver
This option increases the pressure and the
temperature of the water. The washing
and the drying phases are shorter.
The total programme duration decreases
by approximately 50%.
The washing results are the same as with
the normal programme duration. The
drying results can decrease.
How to activate TimeSaver
Press , the related indicator comes on.
If the option is not applicable to the
programme, the related indicator does not
come on or it flashes quickly for a few
seconds and then goes off.
The display shows the updated
programme duration.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener. It
seems that the appliance is not working.
The washing phase starts only after this
procedure is completed. The procedure
will be repeated periodically.
8.1 The salt container
CAUTION!
Only use salt specifically
designed for dishwashers.
ENGLISH
= Acoustic signal off.
11