Specifications; Machine Inspection - RIDGID Power-Spin Bedienungsanleitung

POWER-SPIN® Drain Cleaner
Cable Size
/ " (6 mm) Cable
1
4

Specifications

Drum Capacity.........
Drum Speed................ Maximum 500 RPM
Weight.......................... 4.7 lbs. (2,1 kg)
This machine is made to clean
NOTICE
drains. If properly used it will not damage a
drain that is in good condition and properly
designed, constructed and maintained. If the
drain is in poor condition, or has not been
properly designed, constructed and main-
tained, the drain cleaning process may not
be effective or could cause damage to the
drain. The best way to determine the condi-
tion of a drain before cleaning is through vi-
sual inspection with a camera. Improper use
of this drain cleaner can damage the drain
cleaner and the drain. This machine may not
clear all blockages.
Cable End
Trigger
Figure 1 – Power-Spin
4
Recommended Line
Size & Reach
Line Size Reach
Up to 1 / " 25' (7,6 m)
1
2
(40 mm)
25' (7,6 m) of / "
1
4
(6 mm) Diameter
MAXCORE Cable
Crank
Drum
Handle

Machine Inspection

WARNING
Before each use, inspect your drain clean-
ing machine and correct any problems to
reduce the risk of serious injury from elec-
tric shock, twisted or broken cables, chemi-
cal burns, infections and other causes and
prevent drain cleaner damage.
1. Clean any oil, grease or dirt from all
equipment, including handles and con-
trols. This aids inspection and helps
prevent the machine or control from
slipping from your grip. Clean any debris
from the cable and drum.
2. Inspect the drain cleaner for the follow-
ing items:
• Proper assembly and completeness
• Broken, worn, missing, misaligned or
binding parts
• Smooth and free movement of the
trigger and drum
• Presence and readability of the warn-
ing label (see Figure 2.)
If any problems are found, do not use
the drain cleaner until the problems
have been repaired.
3. Inspect cable for wear and damage –
Look for:
• Obvious flats worn into the outside of
the cable (cable is made from round
wire and profile should be round).
• Multiple or excessively large kinks
(slight kinks up to 15 degrees can be
straightened).
• Space between the cables indicat-
ing the cable has been deformed by
stretch ing, kinking or run in REVERSE.
• Excessive corrosion from storing wet
or exposure to drain chemicals.
All of these forms of wear and damage
weaken the cable and make cable twist-
ing, kinking or breaking more likely dur-
ing use. Replace worn and damaged
cable before using drain cleaner.
4. If using the Power-Spin Drain Cleaner
with a Battery Power Drill, inspect the
drill per it's instructions. Make sure that
the drill is in good operating condition
and the switch controls the drill opera-
tion. Confirm that the drill turns at less
than 500 rpm.