Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
KNOW YOUR PRODUCT
See page 81.
1. Auto-load chuck
2. Tri-beam LED
3. Direction of rotation selector
4. Variable-speed switch trigger
5. Bit storage
6. Single bit
7. Battery port
8. Mode selection button
9. Low speed
10. Medium speed
11. High speed
12. DECKDRIVE mode
13. Handle, insulated gripping surface
MODE SELECTION
The product features electronic speed control. Press the
mode selection button to change the performance of the
product to suit your application.
Changing the speed on an impact driver also effects the
torque. For small screws, use speed 1. For a better control
with mid-sized screws, use speed 2. For maximum speed
and power when driving large screws, use speed 3.
suits driving decking screws. It has a soft start-up to catch
the screw thread, the impact driver then accelerates up to
full speed before slowing down when the screw is almost
without a pilot hole.
MAINTENANCE
WARNING
The product should never be connected to a power
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
WARNING
When servicing, use only original manufacturer's
replacement parts, accessories and attachments. Use of
any other parts may create a hazard or cause product
damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
2
| English
WARNING
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
WARNING
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
LUBRICATION
All of the bearings in the product are lubricated with a
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories, and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
CE conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Please read the instructions carefully
before starting the machine.
No-load speed
V
Volts
Direct current
min
Revolutions or reciprocations per minute
-1
Werbung
Inhaltsverzeichnis
