Indications For Use - Denmat Precision Gebrauchsanweisung

Precision Heavy Body Color: Purple
• Linear dimensional change:
• Recovery from deformation:
• Strain in compression:
• Shore A Hardness:
Precision Putty & Putty Paks Color: Purple
• Linear dimensional change: max. -0.2%
• Recovery from deformation: min. 99.0%
• Strain in compression: <2.5%
• Shore A Hardness: 68-72
• Storage conditions: In a dry place, at 18 –25 °C (64 –77 °F) and relative humidity
of 50% or less. Do not expose to direct heat or sun. Store cartridges upright.
• Disinfection: Use a cold sterilant.
• Electroplating: Impressions may be copper or silver plated.
• Casting: The impression can be poured after 1 hour.

Indications for Use

Precision is an addition-reaction silicon impression material that is ideal for
dual viscosity impression techniques both one-step and two-step as well as for
a variety of dental procedures including, but not limited to, crowns, bridges,
inlays, partial and complete dentures, denture repairs, implants and for forming
functional peripheries.
Working and Setting Times
Precision offers a variable working time and setting reaction that is
temperature controlled. If placed in the mouth immediately after extrusion,
Precision will allow 45 seconds of intra-oral working time. If more time is
required, Precision will allow for 1:45 extra-oral working time. Therefore,
depending on how much working time is required (45 seconds – 1:45),
the total set time will range from 2:45 – 3:45 minutes.
6
Cartridge
max. -0.2%
min. 99.3 %
max. 3.5%
59-63
FatPak
max. -0.25%
min. 99.3%
max. 3.5%
57-63