EcoSmart Fire BK Serie Bedienungsanleitung Seite 8

ENGLISH
How to operate the Burner
Regulating the flame
Wait until the fire is established (approx 10 minutes) before regulating.
To decrease the flame intensity insert the lighting rod tip through the
circular ring and push forward gently to desired setting. Only use the
lighting rod supplied with your EcoSmart™ Fire to avoid hand burns.
To increase the flame intensity insert the lighting rod tip through the
circular ring and pull back gently to desired setting. Only use the
lighting rod supplied with your EcoSmart™ Fire to avoid hand burns.
www.ecosmartfire.com
Baffles
Accessories are available to regulate models that are ON/OFF
functioning only - these baffles are inserted into the burner opening
when cold and not operating - this increases the efficiency of the
burner as well as decreases the output of the burner. Contact your
local retailer/distributor or head office.
Note: Regulatory function and accessories not applicable to BK2UL or
AB3 - in these models, the control must be in the fully ON or fully OFF
position only. The flame cannot be adjusted.
XL900 4 x Baffles
XL500 2 x Baffles
Important: All Burner parts will age over the course of time through
natural processes associated with use, heat and flame.
Please also note that new stainless steel has an oil coating that will burn
off during the first few uses. You will notice an accumulation of carbon
around the top opening of the Burner zone and its vents. This will appear
quickly and is normal. You will need to perform your first maintenance
after approximately 20 litres [5.28 Gal] of Bioethanol burnt.
SCALE 1:10
After this, the accumulation will be far slower and maintenance can
then occur every 50 litres [13.20 Gal] of Bioethanol burnt. If anything
abnormal appears, do not operate the unit. If the fire is running, turn it
off immediately and contact your distributor before using again.
XL700 3 x Baffles