Lighting The Burner - EcoSmart Fire BK Serie Bedienungsanleitung

ENGLISH
How to operate the Burner

Lighting the Burner

Keep hands and face the length of the lighting rod away from the
Burner at all times, particularly when igniting. Before lighting,
ensure that the Burner is clear and ready for use. When lighting the
Burner the slider must be positioned at MAX to allow for correct
ventilation.
Check the slider is free from obstruction and operating smoothly.
Do not smoke while lighting the Burner, and make sure that no one is
in front of the fireplace while igniting the Burner. Only use the lighter
supplied with your EcoSmart™ Fire.
2
1
1. Dip the lighting rod tip into the chamber opening "Burner zone"
to wet the end.
2. Lift the lighting rod away from the Burner (do not drip fuel on the floor).
3. Ignite the lighter and make contact with the lighting rod as if lighting
a candle.
4. Dip the ignited lighting rod back into the Burner zone to ignite the
contained fuel.
5. Allow residual flame on lighting rod to burn out.
NOTE: The XL900 & XL700 is best ignited from the right hand side
of the ignition zone.
Once lit there will be a residual flame on the lighting rod that must burn
out before putting the rod away. If the flame on the lighting rod dies
before reaching the burner, repeat the procedure until successful.
Due to some residual oil in the fibres we use in the Burner there is a
stronger smell when first operating. It will decrease substantially after
the first few times you use the Burner, and even more so over time.
To minimise this, wash the burner out in hot water before using.
The Burner must be completely dry and cool before filling with fuel.
www.ecosmartfire.com
3
4