Oase AquaMax Eco Expert 20000 / 12V Gebrauchsanleitung Seite 22

- EN -
Connecting the pipe
• To connect the pipes, one PVC transition sleeve each is required. PVC transition sleeves are available in specialised
shops.
How to proceed:
• Screw the PVC transition sleeve and seal onto the outlet.
• Attach the PVC transition sleeve to the pipe.
Turning the pump casing to achieve a different position
How to proceed:
 G
Remove the screws for fastening the filter basket and remove the filter basket.
Remove the screws for fastening the stand and remove the stand.
Remove the four screws for fastening the retaining plate and remove the retaining plate.
Remove the four screws and take off the pump casing.
Turn the pump casing, place it onto the motor and fasten with the four screws.
Fit the retaining plate onto the pump casing and fasten with the four screws.
Fit the stand and filter basket in the reverse order.
Connecting the switching power pack to the pump
N O T E
The pump will be destroyed, if water penetrates the plug connectors of the connection line.
• Do not undo the union nuts on the plug connectors.
Once the plug connectors of the filter pump and switching power pack have been inserted and have engaged, they can
only be disconnected by means of a screw driver. (→ Removing the switching power pack)
How to proceed:
 H
• Connect the plug connector of the pump with the plug connector of the switching power pack.
– The stud on the plug connector of the pump engages with the plug connector of the switching power pack.
– The plug connection can later be released with a tool. (→ Removing the switching power pack)
Eco Control Connecting
As an option, Eco Control can be connected to the pump to control it.
• The control unit Eco Control (47673) is available as an accessory for Eco Expert pumps.
• If the pump is integrated in an EGC network, connecting Eco Control is not possible.
How to proceed:
 L
Remove the protection cap from EGC-IN.
Fit the plug connector of the cable and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
22