Troubleshooting - Sensear smartPlug Bedienungsanleitung

12. TROUBLESHOOTING

Having Trouble pairing the headset
Make sure any previously paired devices are powered off. Make
sure the radio is configured with Bluetooth enabled.
Headset and Radio will not connect
Wired:
Make sure the cable is securely fastened to both the Two Way
Radio and the Main Housing.
Bluetooth:
Make sure your radio and headset are paired together and within
range. Try pairing the two devices together again. Make sure the
Two Way Radio is not connected to another device or headset.
Having Trouble Hearing
Check your headset is on. Make sure your radio and headset
are paired, connected and within range. Check the radio's LED
indicator to check transmit/receive is not stuck on. Check
your radio is functioning by turning off the headset and listening
through the radio. If the radio is working, try turning up the
volume control on the headset and on the radio controls.
Having trouble being heard
Check the headset is on. Make sure the radio and headset
are paired, connected and within range. Check your radio is
functioning by turning off the headset and talking through the
radio.Make sure you have fitted the Ear Buds correctly.
Ensure radio gain is set to a reasonable level.
Two-Way Radio distorted
Check your Two-Way Radio volume level. If the volume
is set too high, this may be breaching the volume level
on the smartPlug and affecting the sound quality.
Light Indicator
Red On
Green on
Red slow flash
Green fast flash
Green slow flash
Blue on
Blue slow flash
Blue fast flash
11
Headset Function
Charging
Charge Complete
Battery Low <1hr remains
Quiet mode
situational
awareness active
Bluetooth on and
discoverable
Bluetooth connected
Bluetooth incoming call
DOC00071 - Rev.00