Electrolux EFG60750 Bedienungsanleitung Seite 44

44 electrolux
Activated Charcoal Filter (Recir-
culation Version)
The fi lter is not washable and cannot be
regenerated. It must be replaced when
led S1 fl ashes or at least every 4 months.
EN
The alarm signal will only light up when
the extractor motor is switched on.
Alarm signal activation
• In Recirculation version Hoods, the
Filter saturation alarm can be enabled
on installation or at a later date. Turn
the Lights and the suction Motor off.
• Disconnect the Hood using the Main
switch or the double-pole switch on
the mains power supply.
• Restore the connection by pressing
and holding T1.
• Release the button. All fi ve LEDs are
turned on.
• Within 3 seconds press T1 until LEDs
T1 and T4 fl ash in confi rmation:
-LED fl ashes twice - Activated char-
coal fi lter saturation alarm ENA-
BLED.
-LED fl ashes once - Activated char-
coal fi lter saturation alarm DISA-
BLED.
Maintenance
Reset the alarm signal
• Switch off the lights and extractor
motor.
• Press button T3 for at least 3 sec-
onds, until the leds start to fl ash.
Replace the Filter
• Pull the Comfort Panel to open it.
• Remove the metal grease fi lters
• Remove the saturated activated
carbon fi lter by releasing the fi xing
hooks
• Fit the new fi lter by hooking it into its
seating
• Replace the metal grease fi lters.
Light replacement
20 W halogen light.
• Extract the lamp from the lamp holder
by pulling gently.
• Replace with another of the same
type, making sure that the two pins
are properly inserted in the lamp
holder socket holes.