General Instructions; Installation; Preparing The Cabinet - Electrolux EHG8830X Gebrauchs- Und Installationsanleitungen

General instructions

To ensure safe and efficient operation of this appliance:
– only contact authorised service centres;
– always demand the use of original replacement parts;
– the appliance is designed for non-professional, domestic use; do not modify its characteristics;
– the dataplate gives the symbols indicating the countries for which the instructions apply;
– appliance electrical safety is guaranteed only when it is connected to an earthing system in compliance with the
current regulations;
– do not touch the pot grids during use, since they become very hot. Keep children away from the appliance;
– only use the appliance for cooking food;
– before any cleaning or maintenance operations, or in case of malfunction, disconnect the appliance from the mains
power supply;
– always check that the control knobs are in the off position when the appliance is not in use.
Do not allow children to touch:
– the controls or the appliance in general;
– the packing components (bags, polystyrene, staples, etc.);
– the appliance, during and immediately after use, since the hob becomes very hot;
– an unused appliance (make any potentially hazardous parts safe).
Do not:
– touch the appliance with wet parts of the body;
– use the appliance when barefoot;
– pull the appliance or power cable to unplug it;
– carry out improper or hazardous operations;
– leave the power cables of other electric appliances on hot parts of the appliance;
– expose the appliance to atmospheric agents;
– use the appliance as a support surface;
– use flammable fluids near the appliance;
– use adapters, multisockets or extension leads;
– allow anyone except qualified personnel to install or repair the appliance.
Important
– Do not place unstable or deformed pots on the burners, since they may tip over or cause spills.
– If the appliance has a lid, make sure the burners are cold before closing it.
– Close the gas supply cock when the hob is not in use.
– Before installation, make sure the gas supply is compatible with appliance specifications. The arrangement for the gas
usable is given on the label on the bottom of the tray. This appliance is not connected to a fume extraction device and
must be installed and connected in compliance with the current regulations. Pay particular attention to the applicable
regulations on ventilation. The use of a gas cooking appliance produces heat and humidity in the room where it is
installed. Ensure the room is adequately ventilated: keep natural ventilation openings open, or install a mechanical
ventilation device (extractor hood with exhaust duct). In case of intensive or prolonged use of the appliance, it may
be necessary to provide additional ventilation, for example by opening a window, or more efficient ventilation,
by increasing the fan speed (if present).
The manufacturer declines any liability for damage due to: incorrect installation, improper, wrong or
unreasonable use.

Installation

The necessary operations for installation, including gas and electrical connections, are described below. Such operations
must be carried out by qualified personnel in accordance with current regulations, since their performance by unskilled
people may constitute a hazard.
The manufacturer declines any liability for injury or damage due to non-compliance with these provisions. THE GAS
CONNECTION MUST COMPLY WITH UNI 7129 AND UNI 7131 STANDARDS.

Preparing the cabinet

This handbook regards a class 3 built-in cooking hob.
Prepare the opening in the top according to the measurements given in fig. 1.
The opening must be made in the most convenient position, taking into account that the gas pipe must not come into
contact with the sides of a possible oven under the hob.
The opening of the recess must be at least 55 mm from the rear wall. Any right or left side wall higher than the hob must
be at least 150 mm from the hole in the top.
14