Arrow PT23G Benutzerhandbuch Seite 7

PT23G_Pneumatic_Manual_rev2_Layout 1 9/12/14 4:48 PM Page 7
TROUBLESHOOTING
The following form lists the common operation system with problem and solutions.
Please read the form carefully and follow it.
WA RNING!
!
If any of the following symptoms appears during your operation, stop using
the tool immediately, or serious personal injury could result. Only a qualified
persons or an authorized service center can perform repairs or replacement
of tool. Disconnect tool from air supply before attempting repair or adjustment.
When replacing O-rings or Cylinder, lubricate with air tool oil before assembly.
SYMPTOM
Air leak near top of tool or in
trigger area.
Air leak near bottom of tool.
Air leak between body and
cylinder cap.
Blade driving fastener too
deep.
Tool does not operate well:
can not drive fastener or
operate sluggishly.
Tool skips fasteners.
Tool jams.
PROBLEM
1.O-ring in trigger valve are damage.
2.Trigger valve head are damage.
3.Trigger valve stem ,seal or
O-ring are damaged.
1. Loose screws.
2. Worn or damaged O-rings or
bumper.
1. Loose screws.
2. Worn or damaged O-rings or seals.
1. Worn bumper.
2. Air pressure is too high.
1. Inadequate air supply.
2. Inadequate lubrication.
3. Worn or damaged O-rings or seals.
4. Exhaust port in cylinder head is
blocked.
1.Worn bump amaged spring.
2.Dirt in front plate.
3.Dirt or damage prevents fasteners
from moving freely in magazine.
4.Worn or dry O-ring on piston or
lack of lubrication.
5.Cylinder cover seal leaking.
1.Incorrect or damaged fasteners.
2.Damaged or worn driver guide.
3.Magazine or nose screw loose.
4.Magazine is dirty.
SOLUTION
1.Check and replace O-ring.
2.Check and replace.
3.Check and replace trigger valve stem,
seal or O-ring.
1.Tighten screws.
2.Check and replace O-rings or bumper.
1.Tighten screw.
2.Check and replace O-rings or bumper.
1.Replace bumper.
2.Adjust the air pressure.
1.Verify adequate air supply.
2.Place 2 or 6 drops of oil into air inlet.
3.Check and replace O-rings or seal.
4.Replace damaged internal parts.
1. Replace bumper or pusher spring.
2.Clean drive channel on front plate.
3.Magazine needs to be cleaned.
4.O-ring needs to be replaced.
And lubricated.
5.Replace Sealing washer.
1.Change and use correct fastener.
2.Check and replace the driver.
3.Tighten the magazine.
4.Clean the magazine.
7