Air Supply - Arrow PT23G Benutzerhandbuch

PT23G_Pneumatic_Manual_rev2_Layout 1 9/12/14 4:48 PM Page 5
OPERATING INSTRUCTIONS
Description
Arrow's PT23G pin nailer drives 23G headless pin nails from ½" to 1"(12mm to
25mm) in length. It has a Die-cast aluminum body for strong driving and light
weight hardened oxidized magazine. Also included is a quick release latch for
fast jam releasing and fast loading. Headless pin nails are perfect for decorating
without leaving a mark. With economical air consumption and low noise, it's an
excellent for furniture backs, upholstery, paneling, drawer, rails etc.

Air Supply

1. Use clean, Dry and Regulated compressed air at 60-100psi (4-7 bar)
2. Never exceed maximum and minimum pressure. Too low or too high
pressure would cause noise wear and tear or misfiring.
3. When connecting air supply always keep hands and body away from
discharge area of tool.
4. A filter-regulator-lubrication is required and should be located as close to
tool as possible.
5. Keep air filter clean. A dirty filter will reduce the air pressure to the tool
causing a reduction in power and efficiency.
6. For better performance, install a quick connector in your tool and quick
coupler on the hose if possible.
7. Be sure all connections in air supply system are sealed to prevent air loss.
Quick
Connector
TOOL
Quick
Connector
Quick
Coupler
Air Hose
Filter
Oiler
Quick
Coupler
Regulator
Air
Compressor
5