Assembly The Monitor - REV VD 2073 Montage- Und Bedienungsanleitung

Assembly the monitor (2) (Illus. A+B / page 62 + 63)
Please mount the wall fixing (7) of the monitor on the intended
place (Fig. A). The power line (3) must be placed in the bearing
of the backside. The power line should not be contact the wall
fixing. Connect the Monitor power line colour to colour, then you
can slide the monitor on the wall fixing. Then put the wire of the
telephone receiver in the earphone socket (15)
Connecting up a door opener (Illus. C / page 64)
If an electric door opener (12V=/1A) is used, of specification as
given below, the entrance door can be opened using a button
(16) on the monitor, connected by a 2-core cable which must be
laid from the door intercom to the door opener. The door opener
must allow of 12 Volt DC operation and must be of a maximum
rating of 1 Amp.
oben
18