Laying Or Extending The Cabling - REV VD 2073 Montage- Und Bedienungsanleitung

Fig. 2
Fig. 3

Laying or extending the cabling

The connecting cable (4) included must be laid to the fixing point
of the monitor. Ensure there is enough length to connect up to
the monitor once fitted. If an extension is needed, this can be
made using ordinary 2-core cable to a maximum of 70 metres in
all. Keep an eye out for any difference in colour of the cable.
Make a note of the colours on the extension cable and the
monitor connectors (5) to avoid mistakes in connecting up to the
monitor. The cabling colours of the connectors of the individual
wires of the connection cable (4) are given on the monitor
terminals (6).
17
2. Push a small screwdriver into
the notch and lift the blind off. Now
you can pull off both blinds
upwards or downwards from the
housing (see Fig. 2).
4. Line connection according to
figure C / page 64
5. Fitting the door station with 2
screws (Fig. 3).
Please attend by the installation of
the wire.
6. Push the blinds back on