Assembly The Door Intercom - REV VD 2073 Montage- Und Bedienungsanleitung

Note:
If you are already using a 2 core doorbell system, then you may
use the two doorbell cables to make the connection, as shown
below, and you will not need to put in any further cabling. The
door-opening signal is also transmitted along the same two
cables. The door intercom is designed to be fitted within the wall
rendering. It must be fitted in an area protected form spray and
rainwater, or else appropriate shielding or covering must be
added.
In the outside area near the intercom, the connection cable (4)
should not be laid on the surface of the rendering, but taken
through the wall. This protects it from damage.

Assembly the door intercom

Prepare the wall notch that fits for installing the door station.
The under-plaster box must fit inside the notch; the frame must
cover the notch completely. Dimensions (see Figure 1).
Abb. 1
85 - 90 mm
> 40 mm
ca. 10 mm
X Y
Draw the line approx. 10 mm
from the bottom edge of the
notch into the notch; provide
approx. 10 -15 cm of the line for
connection.
X = line to the monitor
Y = line to the door opener / is
only needed if the door opener
should be connected.
2. Fix the under-paster box
with gypsum in the wall cut-
out, now you can plaster the
complete under-plaster box.
16