Product Description; Intended Use; Open Source Software; Scope Of Delivery - Bosch DCU 100 Originalbetriebsanleitung

en 16 | DCU 100 | Product description
3.

Product description

3.1

Intended use

DCU 100 is a tablet for the workshop area for the Bosch
diagnostic software "ESI[tronic] 2.0" or the Bosch
Emissions Analysis software "BEA-PC".
!
DCU 100 may only be operated with the storage
battery of Robert Bosch GmbH (Model: 2ICR18/65-2)
and the power supply unit of Elementech International
Co. LTD. (Model No.: A160-1120500M).
!
If the DCU 100 and the supplied accessories
are operated contrary to the way specified by
the manufacturer in the operating instructions,
the protection provided by the DCU 100 and the
supplied accessories may be compromised.
!
If ESI[tronic] 2.0 and BEA-PC are installed on DCU 100,
then it is always the case that only one of the two
programs can be opened. This means that before BEA-
PC can be started, ESI[tronic] 2.0 must be closed (and
vice-versa).
!
The installation of additional software on the
DCU 100 may impair the performance of the DCU 100
system and the DCU 100 may become slower in
general.
!
The DCU 100 must not be exposed to sources
of heat (e.g. direct sunlight), impact, vibration,
magnetic fields, and excessive contamination.
i
The installed operating system is
Windows 10 IoT (64-bit).
3.2

Open Source Software

The overview of open source software licenses for
DCU 100 is available as an Adobe pdf document at
'C:\IA4KD\OPEN_SOURCE'.
|
1 689 989 283 2019-06-24
3.3

Scope of delivery

i
The scope of delivery depends on the product variant
ordered as well as the special accessories ordered,
and can deviate from the following list.
Designation
DCU 100
Storage battery
External DVD ROM drive with
USB connecting cable
Case
Power supply unit with
Power supply cable
Connection cable for cigarette lighter socket 1 684 465 784
Stylus (1x)
Recovery DVD
Original operating manual
3.4

Transport

The DCU 100 connecting cables must be removed for
transportation. Also, the DCU 100 should be transported
and stored in the case supplied. Furthermore, the DVD
drive should be stored and transported in its original
packaging in the case.
3.5

Device description

The DCU 100 is a portable, mobile tablet PC for
workshop use. It is operated by means of a pen (for
the LCD touch screen) and a virtual keypad. The data
and measured values can be printed out by way of the
USB port on an external printer (special accessory).
The DCU 100 and the accessories are supplied in a
protective case.
1
Fig. 1: DCU 100
1 LCD with touch screen
2 Interfaces
3 Function key ƒ
4 Power key
Order number
–
1 687 335 042
–
–
1 687 023 697
1 684 461 186
–
–
–
2
4 3
Robert Bosch GmbH