Technical Specifications - Safescan 2600 series Handbuch

English | nEdErlandS | dEutSch | FrançaiS | ESpañol | italiano | portuguêS
6.3 Detecting suspected notes
error message
Slant notes
Chained notes / Double notes
Incomplete notes
UV Suspected
IR Suspected
MG Suspected
Width error
Different denomination
Cannot Judge Denomination
Receiver stack full

7.0 TECHNICAL SPECIFICATIONS

Dimensions
Weight
Note size range
Speed
Hopper capacity
Stacker capacity
Power source
Power consumption
Operating Temperature
Causes anD solutions
Make sure to place banknotes neatly and centered on the hopper. If the error
message frequently occurs then fine-tune the Hopper-adjusting-screw slightly
toward clockwise direction (+) (for details see chapter 2.7).
Sometimes banknotes are stuck/connected or folded together. Check the
banknotes and re-count. If the error message frequently occurs then fine-tune
the hopper-adjusting-screw slightly toward clockwise direction (+) (for details see
chapter 2.7).
Incomplete/damaged banknote. Remove and check the banknote.
press [START] to continue.
Counterfeit or suspicious banknote. Remove the banknote from the stacker and
press [START] to continue counting.
When incorrect identification of genuine banknotes frequently occurs: adjust
the sensitivity level to a lower level (for details see chapter 4.1).
Non-conforming size of banknote, remove and check the banknote.
press [START] to continue.
Remove the different banknote denomination, remove counted notes and
re-count bundle.
Remove and re-count bundle.
Stacker capacity is 220 notes.
Remove notes from the stacker.
243 x 287 x 248 mm
6.5 kg
50 x 110 mm ~ 90 x 180 mm
High speed: 1500 notes/minute
Medium speed: 1200 notes/minute
Low speed: 800 notes/minute
300 notes
220 notes
AC 100-240V / 50-60Hz
60W
0--40°c
9