Cleaning And Maintenance - Zanussi SERVICE 7000 THES7000 Benutzerinformation

audible confirmation of:
• cycle end
• anti-crease phase start and end
• cycle interruption
• error
TIME
after setting the Time programme. You can select a
programme duration from 10 mins to 2 hrs in 10-mi-
nute steps.
DELAY START
allows to delay the start of a drying programme from
minimum of 30 min. to maximum of 20 hours. Press
the Delay Start button repeatedly until the desired delay
start is shown on the display
Setting child lock
The child lock can be set to prevent a programme being
accidentally started or a programme in operation being
accidentally changed. The child lock function locks all
buttons and the programme selector. The child lock can
be activated or deactivated by holding down the
TRA DELICATE and
ously for 5 seconds.
The icon appears in the display to indicate that the
child safety device is activated.
Any changes of drying parameters require child lock
deactivation.
The child lock cannot be deactivated in the last phase of
the drying cycle.
Changing programme
To change a programme which is running, first cancel it
by turning the programme selector dial to

Cleaning and maintenance

Emptying the water reservoir
Empty the water reservoir after every drying cycle.
INTENSIVE buttons simultane-
OFF. Select
the new programme and press the
ton.
The programme can no longer be changed directly
once the programme has started. If nevertheless
there is an attempt to change the programme on the pro-
gramme knob, the programme progress display and the
maintenance indicators flash. If an option button (exclud-
ing the BUZZER button) is pressed,
the display. The drying programme is not however affec-
ted by this (laundry protection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the display shows the
anti-crease icon and flashing as well as warning
lamps: FILTER and
ZER button has been pressed, an acoustic signal sounds
intermittently for about one minute.
The drying cycles are automatically followed by an
anti-crease phase which lasts around 30 minutes.
The drum rotates at intervals during this phase. This
keeps the laundry loose and free of creases. The laundry
can be removed at any time during the anti-crease phase.
(The laundry should be taken out towards the end of the
anti-crease phase at the latest to prevent creases from
EX-
forming.)
1. Open door.
2. Before removing the laundry, remove fluff from the
micro-fine filter. It is best to use a damp hand for
this purpose. (See "Cleaning and maintenance"
chapter.)
3. Remove laundry.
4.
Turn the programme selector to
5. Close the door.
START/PAUSE but-
appears on
FULL TANK . If the BUZ-
off.
23