Zanussi SERVICE 7000 THES7000 Benutzerinformation Seite 18

Removing transport safety packaging
Caution! Before use all parts of the transport
packaging must be removed.
1. Open loading door
3. Remove foil hose and polystyrene padding from the
machine.
Electrical connection
Details on mains voltage, type of current and the fuses re-
quired should be taken from the type plate. The type plate
is fitted near the loading aperture (see "Product descrip-
tion" chapter).
Warning! The manufacturer declines any
responsibility for damage or injury through failure
to comply with the above safety precautions.
Should the appliance power supply cable need to be
replaced, this must be carried out by our Service Center.
18
2. Pull off adhesive strips
from inside machine on
top of drum.
Warning! The power supply cable must be
accessible after installing the machine.
Door reversal
To make it easier to load or unload the laundry, the door
can be reversed. The door must only be reversed by an
authorised service engineer. Please contact your local
Service Force Centre. The engineer will carry out the door
reversal at your cost.
Special accessories
• stack kit
Available from your Service Force Centre or your
specialist dealer
These intermediate installation kits can be used to ar-
range the dryer and an washing machine (60 cm wide,
front loaded) as a space-saving washer/dryer stack.
The washing machine is at the bottom and the dryer is
at the top.
Read carefully the instructions supplied with the kit.
• drain kit
Available from your Service Force Centre or your
specialist dealer
Installation kit for direct draining of condensate into a
basin, siphon, gully, etc. The condensate tank then no
longer has to be drained, it must however remain in its
intended position in the machine.
Read carefully the instructions supplied with the kit.
• pedestal with the drawer
Available from your Service Force Centre or your
specialist dealer
To situate the dryer in optimal high and have some ad-
ditional space to store (e.g. laundry).
Read carefully the instructions supplied with the kit.