Replacing The Fuses - Beta 1760/RMS Bedienungsanleitung

REPLACING THE FUSES

WARNING:.
To.avoid.electric.shock,.disconnect.the.test.leads.from.any.source.of.voltage.before.removing.
the.fuse./battery.cover.
1 Disconnect.the.test.leads.from.the.meter.and.any.item.under.test.
2 Open.the.fuse.door.by.loosening.the.screw.on.the.door.using.a.Phillips.head.screwdriver.
3 Remove.the.old.fuse.from.its.holder.by.gently.pulling.it.out..
4 Install.the.new.fuse.into.the.holder.
5 Always.use.a.fuse.of.the.proper.size.and.value.(0.2A/600V.fast.blow.for.the.110mA.range,.
10A/1000V.fast.blow.for.the.10A.range).
6 Put.the.fuse.door.back.in.place..Insert.the.screw.and.tighten.it.securely.
WARNING:.
To.avoid.electric.shock,.do.not.operate.your.meter.until.the.fuse.door.is.in.place.and.fastened.
securely.