Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Operation; Control Panel; Turn On - CombiSteel 7450.0745 Gebrauchsanweisung

Dessert show display
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

INSTALLATION

Note: If the unit has not been stored or move in an upright position, let it stand upright for approximately 12
hours before operation. If in doubt allow to stand.
1. Remove the appliance from the packaging and the protective film from all surfaces.
2. Avoid positioning the appliance in direct sunlight or damp areas.
3. Insert the slide-out shelf/shelves at the desired levels and place the smaller shelf/shelves on the floor
of the appliance.
4. If necessary, adjust the screw feet of the appliance to make it level.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.

OPERATION

CONTROL PANEL

The control panel is located below the doors on the front of the appliance.

TURN ON

1. Close the door of the appliance.
2. Connect the appliance to a mains power supply.
Note: The cooling light is illuminated when the appliance is chilling the interior cabinet.

TO CHANGE THE OPERATING TEMPERATURE

The default operating temperature is 2°C. To display the operating temperature (set point), press and
immediately release the SET button.
To change the operating temperature:
1. Press the SET button. The display will flash.
2. Press the
3. Press the SET button to store the temperature.

MANUAL DEFROST

The cooler feature an automatic defrost. However, should the appliance require an additional defrost period
press and hold the
button for 6 seconds.
Automatic defrost cycles are every 6 hours and last 20 minutes (factory defaults).
Note: If a manual defrost is started this resets the automatic defrost timer. During defrost periods the defrost
light is illuminated.
CLEANING, CARE & MAINTENANCE
Switch off and disconnect from the power supply before cleaning.
Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmful residues.
Always wipe dry after cleaning.
An agent or qualified technician must carry out repairs if required.

CLEANING THE CONDENSER

Periodically cleaning the condenser can extend the life of the appliance. We recommend that our agent or
qualified technician clean the condenser.
Note: Use a soft brush or vacuum cleaner to clean the fins of the condenser, taking care not to damage the
fins.
or
buttons to display the required temperature.
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis