Philips hd 3600 Bedienungsanleitung Seite 10

ENGLISH
10
C
3 Push the tube connector into the opening in the tap unit.You
will hear a click.
Step 4: placing the keg into the appliance
Never place the keg into the appliance if the tap unit has not been
placed properly onto the keg. (see 'Step 2: placing the tap unit onto the
keg').
Always make sure there is a tube in the tap unit before placing the keg
with the assembled tap unit into the appliance.
C
1 Open the doors by pressing the release button.
C
2 Lift the two blue locking levers completely.
C
3 Place the keg with the assembled tap unit into the appliance by
tilting it slightly forward.
- First put the keg on the cooling plate of the appliance.
- Then put the keg upright by sliding the tap unit between the blue
locking levers.
After you have installed the keg (even the first time), the pump
will run for a few seconds.
C
4 Push down the blue locking levers until they are in horizontal
position.
Note: if you are unable to put the locking levers in horizontal
position, the keg has not been put into the appliance in the right
position.Take the keg out and follow steps 1 to 3 again.
The pump and the cooling system will start to work soon after
you have installed the keg.