TECNA 9336AX Bedienungsanleitung Seite 5

ATTENTION: instructions marked by symbol
WARNING: this device is suitable only for use in environments having potentially explosive atmospheres for GAS, DO NOT use this device in
environments having potentially explosive atmospheres for DUST.
Plate description
1 manufacturer and relative address;
2 ATEX Marking;
Ex = symbol as identified in directive 94/9/EC;
I I = group, surface;
2 = category;
G = equipment that may be installed in zones with
potentially explosive atmospheres comprising
inflammable gas;
c = protection by constructional safety "c",
EN 13463-5:2011;
I I = for all gasses;
T6 = temperature class;
3 item code;
4 year of manufacture;
5 serial no.;
6 admissible lower capacity range;
7 admissible upper capacity range;
8 balancer weight;
9 stroke;
10 CE mark.
Install the balancer before using it. This operation is to be carried out by skilled personnel who must comply with the directions outlined in this manual:
a wrong installation could cause injury/damage to people/property.
This manual contains important information that the user must adhere to in order to use the balancer safely. Be sure to have clearly understood all
the instructions before using the balancer. Failure to do so could cause injury.
The balancer was built in conformity with European Community Directives that were pertinent and applicable when the balancer was put on the market and that entail
the CE marking of the product.
Intended conditions of use
The balancers are designed to balance the weight of tools and utensils in general and are to be used by one operator at a time. The balancer may be used in an assembly
line, in single workplaces, in professional or private environments, as a hobby, etc.
Always operate, inspect and maintain this balancer in perfect working order in accordance with all regulations pertinent to balancers, tools and
workplaces.
Use contraindications
Do not use the balancer in environments with potentially explosive atmospheres.
Do not permit children or people under age to use the balancer.
Do not work, transit or linger underneath the balancer.
When using balancers, always fully and duly comply with the standards and laws in force in the country in which they are used.
TECNA S.p.A. will not be held liable for any damage or problems caused by customers using these balancers for any other application.
Choosing the balancer
ATTENTION: when choosing the balancer, check that the ATEX classification on the plate is suitable to the environment, the type of potentially
explosive atmosphere and the intended use.
ATTENTION: if the balancer must work in contact with chemically aggressive powder, liquid, or gas, verify chemical compatibility by calling TECNA
spa.
are critical for the use of the balancer in environments with potentially explosive atmospheres.
1
4
Translation of the Original Instructions
2
10
5
3-6-7-8-9