SOLAC MD7411 Gebrauchsanleitung Seite 14

DESCRIPTION
A Lock/unlock button
B Led operation indicator
C Swivel cord
D On/off switch
E Clossing lever
F Ceramic coating cylinder
INSTRUCTIONS
FOR USE
OBSERVATIONS:
- Make sure that all the
product's packaging has been
removed.
- The appliance may produce
a peculiar smell the first few
times it is used. This is normal
and will stop happening with
use.
- A slight amount of smoke
may be detected with each
use. This could be due to the
evaporation of fat from the
scalp, hair product residues
(un-rinsed conditioner, hair
lacquer, etc.) or hair moisture.
- The ion generator inside the
device releases ions against
static electricity, leaving your
hair soft, shiny and frizz-free.
- Note: it is completely normal
to hear a slight crackling-like
noise. This is the characteristic
noise of the ion generator.
USE
- Unroll the cable completely
before plugging it in.
- Connect the appliance to the
mains.
- Turn the appliance on using
the on/off switch.
- The indicator lamp (B) will start
flashing until the device rea-
ches temperature. Leave the
appliance to heat up for about
3 minutes until the indicator
lamp stops flashing and 2
beeps sound.
- Unlock the appliance by using
the lock/unlock button (A)
- Take a strand of hair, maxi-
mum 3 cm wide. Use the comb
to untangle it.
- Bring the device up to the hair
and position it in the proper
direction (Fig.1). The cavity
formed by the cylinder facing
down and towards the head.
(As shown by the arrows on
the device) and put the strand
of hair into the device. (Fig.2).
- Note: To use correctly, make
sure no hair sticks out the si-
des of the opening. Do not pull
on the hair before operating
the handle.
- If you do not pay attention
to the instructions, your hair
may get caught inside the
device.