Werbung
USE OF THE REFRIGERATOR
Operation
To start the appliance, turn the thermostat knob,
located inside the compartment, to the required
position. This thermostat has six operating
positions and an Ç0È (Stop) position.
To stop the appliance, turn the thermostat knob
to the ÇOÈ position. The freezer compartment
will continue to operate.
Temperature regulation
The temperature is automatically regulated and can
be increased to achieve a higher temperature
(warmer) by rotating the thermostat knob toward
lower settings or reduced (colder) rotating the knob
towards higher settings.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
refrigerator depends on:
room temperature;
how often the door is opened;
the quantity of food stored;
location of appliance.
A medium setting is generally the most suitable.
Movable shelves
The walls of the refrigerator are equipped with a
series of runners so that the shelves can be
positioned as desired.
For better use of space, the front half-shelves can lie
over the rear ones.
Positioning the door shelves
To permit storage of food packages of various sizes,
the door shelves can be placed at different heights.
To make these adjustments proceed as follows:
Gradually pull the shelf in the direction of the arrows
until it comes free, then reposition as required.
52
Important
If the ambient temperature is high or the
appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
continuously causing frost to form on the rear
wall. In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.
Fresh food refrigeration
To obtain the best performance:
¥
do not store warm food or evaporating liquids in
the refrigerator;
¥
do cover or wrap the food, particularly if it has a
strong flavour.
¥
Position food so that air can circulate freely round
it.
D338
PR249
PR250
Ferner ist auch am hinteren Einbauschrankteil ein
LŸftungskamin mit folgenden Ma§sen notwendig:
Tiefe
50 mm
Breite
540 mm
GerŠt in die Nische einschieben bis die
Anschlagleiste (A) unten am Mšbel anliegt.
TŸr šffnen und GerŠt gegenŸber der Bandseite an
die Mšbelseitenwand anrŸcken. GerŠt mit den 4 bei-
liegenden Schrauben befestigen.
BelŸttungsgitter (C) und Scharnierabdeckung (D)
aufstecken.
Fugenabdeckprofiloben um die Winkeldicke
ausschneiden und zwischen GerŠt und Mšbelseiten-
wand eindrŸcken.
13
B
T H
PR01
A
D023
D
C
D723
D724
13
Werbung
Kapitel
