Battery Status - Asus ROG CHAKRAM Schnellstartanleitung

Mapping your gaming mouse as a gamepad for Steam
You can setup your gaming mouse as a gamepad for Steam using the gamepad profile (defaulted to Profile 3).
NOTE: You may customize your gamepad profile or reset it to the default Profile 3 using ROG Armoury II.
1. Connect your gaming mouse to your computer.
2. Launch Steam, then go to Settings > Controller > GENERAL CONTROLLER SETTINGS.
3. Switch your gaming mouse profile to your gamepad profile (defaulted to Profile 3).
4. Check the Xbox Configuration Support and Generic Gamepad Configuration Support options.
5. Under Detected Controllers, select ROG CHAKRAM : Generic Gamepad.
6. Map the Backward button, Forward button, Scroll wheel click, and Right button on your gaming mouse
to the Primary Action, Go back, Tertiary, and Secondary Action commands.
7. Map the x-axis and y-axis of the Analogue stick to the Left Stick X and Left Stick Y commands.
8. Press Esc on your keyboard, then click SAVE to complete.
Specifications*
Resolution
100 DPI to 16000 DPI
* You may customize the DPI settings for DPI 1-4 through Armoury II or the DPI On-The-Scroll tuning function.
Using the DPI On-The-Scroll tuning function
The DPI On-The-Scroll tuning function allows you to customize the DPI of your gaming mouse without using
Armoury II.
1. Press and hold the DPI button for 3 seconds until the LEDs on your gaming mouse light up.
2. Scroll the scroll wheel forwards or backwards to adjust the DPI. The LED color hue on your scroll wheel will
differ depending on the DPI adjustment.
NOTE:
• The DPI increments at 100 DPI per scroll forwards and decrements at 100 DPI per scroll backwards.
• The DPI ranges from 100 DPI (blue) to 16000 DPI (red).
3. Press the DPI button once you have finished customizing the DPI value to save the changes made.

Battery Status

The LEDs on your gaming mouse will turn red (breathing) when the battery power is below 25% in Bluetooth or
RF 2.4G mode. You may charge your gaming mouse by using the bundled USB cable or any Qi wireless charger.
Updating the firmware and customization
1. Connect your gaming mouse to your computer using the bundled cable.
2. Download and install the Armoury II software from
https://www.asus.com/Keyboards-Mice/ROG-Chakram/HelpDesk_Download.
3. Follow the software instructions to update your gaming mouse's firmware.
4. Customize your gaming mouse using Armoury II.
ROG Chakram Gaming Mouse
DPI 1 DPI 2
400 DPI 800 DPI
DPI 3 (Default) DPI 4
1600 DPI 3200 DPI
7