OEZ MP-BC Serie Gebrauchsanweisung Seite 8

Motor drive automatic mode presetting
21
edvolby automatického provozu motorového pohonu
Automatic
Switch
mode
position
Preset
winding up
1 *)
2
winding up
Simultaneous
3
loading and
switching on
Motor drive is out of operation, red LED goes on. In this mode the drive cannot
be remotely controlled by ON and OFF signals. However there is full supply
voltage on the drive, and this mode must not be used for the case of drive
handling by the operator!
*) Standard factory setting of the switch
**) When the circuit breaker is switched off by motor drive electrically by OFF button, the circuit
breaker control lever will get automatically into the loaded position
mode setting.
***) By pressing the OFF button, the circuit breaker motor drive is only loaded to position
Circuit breaker
Preset
switching off
description
to position
Automatic
- By overcurrent
release
is on
By inspection
push-button
Automatic
- By auxiliary
is off
release
By TEST button
Circuit breaker
loading to
**) position
Motor drive
performs
automatically
The operator must press
the button
By pressing the ON button, the circuit
breaker motor drive is loaded and
switched on ***)
- 8 -
Mode 1
Režim 1
Mode 2
Režim 2
Mode 3
Režim 3
Circuit breaker
switching on to
position
Pressing the ON
button
Pressing the ON
button
irrespective of automatic
.
Mode
Auto
ON
Auto
OFF
2 in 1
Warning!
991150h Z00