Candy PDDG 31/1 Gebrauchsanleitung Seite 31

BARBECUE and FRYER ELECTRIC HOB
BARBECUE
USE :
The BARBECUE electric heating element is controlled by a power regulator. The more the knob is
turned towards the max. setting, the more often the heating element will come on, keeping the heat
needed to cook the chosen type of food constant. Setting is on a gradual scale. The intervals
between heating element switch-ons will vary depending on the knob setting, chosen to suit cooking
requirements.
To turn on the element, turn the knob clockwise; this sets the relative thermostat, with settings from
"1" to "10". ( Fig. 13 )
The pilot light turns on to show that the element is in operation.
Using the grid: Before using the grid, it is always advisable to check that it is firmly positioned and
correctly placed on the hob. Also check that the rubber pads they rest on are intact and properly in
place.
Lava rock: place the rock inside the tray provided and dispose of the bag. Once it is in place, turn on
the heating element.
ADVICE AND WARNINGS:
never switch on the appliance with the heating elements turned out of the tray;
never switch on the appliance unless the tray is present;
to cook without the lava rock, pour ¼ of a litre of water into the basin underneath the heating
element. This reduces smoke and grease splashes which may stain the surface of the hob;
for the best results, the lava rock should be preheated for at least 10 minutes on setting 1. The
first time the appliance is used, this precaution will reduce the risk of foods absorbing the smells
generated by heating element manufacturing residues.
After cooking, turn knobs back to the "0" setting.
CLEANING:
The BARBECUE is easier to clean when it is still warm. Remove the grid, lift up the front of the
heating element and the remove the basin.
Clean with hot water and a normal detergent, or in the dishwasher. Put back in place on the perfectly
dry surface of the hob.
29