Reference Point For Measuring; Units Of Measure; Switching Between Units Of Measure; Additional Features - Gross Kompakt 70 Betriebsanleitung

REFERENCE POINT FOR MEASURING

• Default reference point is the bottom side.
• The distance meter has three reference points for measuring:
upper side, bottom side and extensible stop.
• Press to change reference point; switching is made after
each pressing. Sequence of switching: upper side — threaded
nut on the case — bottom side.
Hold to change unit of measure.
Units of measure change every time you press this button.

SWITCHING BETWEEN UNITS OF MEASURE

meters
Length m
Area m2
Volume m3
20
Icon of reference point

UNITS OF MEASURE

feet inches 0'0" 1/32 inches
ft in 0'0" 1/32 in
ft2 ft2 ft2 ft2
ft3 ft3 ft3 ft3

ADDITIONAL FEATURES

1. AREA MEASUREMENT
• Please press
• Upon switching to area measuring mode, laser is activated.
• Follow the instructions on the main screen to measure width
and length.
• All steps finished, measuring result will be showed on the
screen.
• Hold to change units of measure.
Stand-by screen Area measuring
m3
once to enable area measuring.
screen
Area measuring steps
1 × 2 = А