Operation; Cleaning Of Water Inlet Strainer; Winterizing - Dometic Remote Water Pump Montage- Und Bedienungsanleitung

Remote Water Pump
7

Operation

!
CAUTION!
Shut off power to remote water pump when leaving the boat
unattended.
I
NOTE
 The remote water pump is designed for intermittent use only.
 The remote water pump operates normally up to about 30 PSI
(2.06 bar).
When the flush switch is activated for flushing or adding water to the toilet
bowl, the water pump delivers water to the toilet bowl while the switch is
pressed.
8

Cleaning of water inlet strainer

➤ Periodically clean the water inlet strainer of any debris which may have
accumulated, especially if the water flow to toilet has become noticeably
slower.
➤ Unscrew the clear reservoir from the strainer body.
➤ Rinse out the debris.
➤ Screw the reservoir securely onto the body.
9

Winterizing

➤ Close seacock at water inlet.
➤ Disconnect water line from inlet seacock.
➤ Turn on power to pump by pressing flush switch. Keep flushing until water
is expelled through toilet.
➤ Fill a container with potable water system antifreeze.
➤ Submerge open end of inlet water hose into container.
➤ Press and hold flush switch to pump antifreeze mixture into toilet all the
way to top of toilet rim. Make sure pump does not start pumping air.
EN
Operation
13