Sanus CFR1615 Handbuch Seite 19

Drill remaining pilot holes as illustrated.
8
CAUTION:
holding power of the lag bolt. To avoid potential
injuries or property damage: pilot holes MUST
be drilled to a depth of 89 mm (3.5 in.), using a
5.5 mm (7/32 in.) diameter drill bit.
Improper use could reduce the
5.5 mm
(7/32 in.)
89 mm
(3.5 in.)
9
Tighten lag bolts [14] only until the washers [11]
and [12] are pulled fi rmly against the brace [03].
CAUTION:
holding power of the lag bolt. To avoid potential
injuries or property damage DO NOT over-
tighten the lag bolts [14].
[12]
[14]
[14]
[11]
[12]
[14]
Improper use could reduce the
13mm
(1/2 in.
)
19