Maxi-Cosi CabrioFix Gebrauchsanweisung Seite 18

EN
CabrioFix car use
1. Always check to make sure the car seat can be
installed properly in your car before purchasing it.
2. Make sure that any fold-down rear seat is locked into
position.
3. Prevent the CabrioFix from becoming trapped or
weighed down by luggage, seats and/or slamming
doors.
4. Make sure that all luggage and other loose objects
are secure.
5. The safest place for your baby is the rear of your
vehicle, however if you need to install the seat in the
front passenger seat, please ensure that any airbag
is deactivated.
6. Only use a forward-facing seat that is fitted with a
3-point safety belt that complies with the ECE R16
standard (at a minimum).
7. Make sure the car safety belt buckle runs in a straight
line and stays below the belt hook of the CabrioFix.
See the p.6 example.
8. The car safety belt must be threaded along
all blue markings. For proper installation
instructions, see pages 6-7 and/or the sticker
on the side of the CabrioFix.
9. Always cover the CabrioFix when exposed to direct
sunlight in the car. Otherwise, the cover, metal and
plastic parts could become too hot for your child's
skin.
WARNING :
The CabrioFix may only be installed in
a rear-facing position in the car.
20
CabrioFix in aeroplanes
• Installation of the CabrioFix on an aircraft seat
differs from the installation on a car seat.
• Installing the CabrioFix with a 2-point safety belt is
only allowed when used in an aircraft.
• In an aircraft, the CabrioFix may only be used on
forward-facing passenger seats.
• The belt buckle must not be positioned within the
belt guiding of this car seat. Otherwise a safe
attachment does not exist.
• The CabrioFix must remain belted on the aircraft
seat, even when unoccupied.
• The CabrioFix is only for use on an aircraft seat
authorized by the airline.
• The safety of your child for not complying with the
installation and instruction manual is not
guaranteed.
CabrioFix maintenance instructions
1. The CabrioFix must undergo regular maintenance.
Do not use lubricants or aggressive cleaning agents.
2. The cover, cushions and belt pads of the
CabrioFix can be removed in order
for these to be cleaned (also see washing
instructions). The flexible plastic edge can be
cleaned with water, soap and a soft cloth.
3. If the cover needs to be replaced at any time, only
use official fabrics.