Power Supply; Software-Installation; Safety Instructions; Frequently Asked Questions - i-tec MySafe Series Gebrauchsanweisung

2. While the case is connected and switched-on, push the Reset button for 5 seconds.
The RAID field will be readjusted.
3. Disconnect and connect the case again
4. Format the disks.

POWER SUPPLY

In case that the case is not sufficiently powered by means of a USB-C/USB 3.0 port, we
recommend that you connect an extern 5 V power source.
SOFTWARE INSTALLATION
Windows 7/8/8.1/10 32/64bit, Mac OS X, Linux, Android, Chrome
At connection of the device to a computer, detection and automatic installation of the
drivers from the system will be performed.
Remarks: At operation, the case surface can be heated up. This is a usual operating
feature and is not a defect. This way, the electronics are being cooled. We recommend
that you not cover the case by things.
Remarks: For correct function of the device, firstly it is necessary to format the new disk
Proceed according to the below mentioned instructions. As far as the disk was earlier
used, then this might not be a necessity. By formatting, you will always lose your already
saved data.
Remark: We recommend that you save essential or valuable data on more than one disks
or other recording media.

SAFETY INSTRUCTIONS

• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping and falling to the
ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the ground.
• Check functionality when the cover is broken.
• Send the device back if it does not work in accordance with the user manual.

FREQUENTLY ASKED QUESTIONS

Available on our website www.i-tec.cz/en/ on the "FAQ" tab of this product.
Quick Start
| 5
ENGLISH