The Watch Has 5 Modes Of Operation; Time; Second Time Zone; Alarm (Alarm) - Pro 1-Ld4497 Bedienungs- Und Sicherheitshinweise

digit by pressing SET. Now the height display will appear. Set your height in the
same way and confirm the setting by pressing SET.
Complete the setting procedure by pressing MODE.

The watch has 5 modes of operation

Press MODE to select the mode of operation of the watch.
The order of the modes is:
Additionally, each mode of operation has several sub-features.
The sub-features can always be reached by pressing SEL.

Time

Repeatedly press MODE to select time mode (ZEIT/TIME). Press SEL to select the
sub-features of the time mode.
Alarm, Timer, Time.
Press and hold SET for 3 seconds to access setting mode.
The display will show EINSTELLEN/HOLD TO
SET and the 12 or 24 hour selection will blink
on the display.
Now the basic settings will follow as described
in the chapter "Setting up the heart rate monitor watch".
Exit setting mode by pressing MODE.
Notes: Press SET and SEL simultaneously to totally reset the watch. This is the only
way to change language and the units of measurement.
- 65 -

Second time zone

Press and hold SEL for 3 seconds. The watch will switch to the second time zone
display and T2 will appear on the display. Setting the second time
zone can be accomplished in the same way as described in the
chapter "Setup of the heart rate monitor".
Press and hold SEL for 3 seconds to return to normal time mode T1.

Alarm (ALARM)

Press SEL to select the sub-features. Press and hold SET for 3
seconds to enter setting mode.
"AL" will appear on the display and the minutes of the alarm time
will blink.
Press SEL to set the minutes and press SET to confirm your setting. Set the hours in the
same way.
You may optionally set the month and day as well.
If neither month nor day are set the alarm will sound daily. If the day is set, the alarm
will sound monthly. If both the month and the day are set the alarm will sound only
at the set date.
The hourly chime setting will now appear on the display.
Press SEL to select a setting and confirm your setting by pressing SET (ON/EIN
=on, OFF/AUS =off). If the chime is activated, the bell symbol
will appear and the watch will chime at the beginning of every
hour.
Exit setting mode by pressing MODE.
The alarm can be activated or deactivated by pressing SET. If the alarm is activated
the alarm symbol will appear.
When the alarm sounds, press SET, SEL or MODE to stop the alarm.

Snooze feature

If no button is pressed when the alarm sounds, the alarm will shut off after about 30
seconds and the symbol will blink on the display. The alarm will
stop and will resume after sounding after about 90 seconds. The
process will repeat itself 4 times.
- 66 -