Manual Release - Motostar MP100 Gebrauchs- Und Wartungsanleitung

control device in maintained action mode, constantly check
that there are no people loitering near the gate's moving
parts Continue in this way until the command is released
• Frequently inspect the installation to check for any
imbalances and signs of wear and tear to cables, springs
and supports Do not use if repairs or settings are required
• If any repairs or changes are made to the system, do
not use it until safety conditions are restored by skilled,
qualifi ed staff. • Cut off the electric power before releasing
the operator for manually opening the gate, and before
any procedure, to prevent any hazardous situations. Read
the instructions • If the power-supply cable is damaged, it
must be immediately replaced by the manufacturer or by
an authorized technical assistance center, or in any case,
by qualifi ed staff, to prevent any risk • It is forbidden to
access any protected internal parts • The device emits a
level of acoustic pressure equal or inferior to 70 dB (A) • In

MANUAL RELEASE

The manual release may cause an uncontrolled movement of the gate due to mechanical malfunctions or to
parts being off balance.
The operator is fi tted with a reversible gearmotor. During any power outages, power cut offs by differential switch or from an
emergency button, the operator lets you manually open and close the gate. (fi gure
Once the current is restored, send a command via the transmitter so that the operator can resume its normal operation.
case of any malfunction or structural damage, immediately
stop operation and call for qualifi ed technical assistance.
The fi gure shows an installation highlighting the main
danger-points for people:
danger of high voltage;
danger of feet crushing;
danger of hand entrapment;
)