How To Install The Product; Mount The Video Encoder; Connect The Cables And Insert The Sd Memory Card - Axis Q7424-R Mk II Handbuch

How to install the product

Mount the video encoder

The AXIS Q7424-R Mk II can simply be placed on a flat surface or mounted. See Hardware Overview
on page 10.
1. Punch out the protective pads and stick them under the video encoder to prevent
scratches on the surface where the video encoder is placed.
2. Place the video encoder against the wall, and mark the four mounting holes.
3. Drill the four mounting holes.
4. Attach the encoder to the wall using screws appropriate to the wall material.

Connect the cables and insert the SD memory card

1. Connect the encoder to the network using a shielded network cable or an SFP module. If
using PoE see note below.
2. Optionally connect external input/output devices, e.g. alarm devices. For information on
the terminal connector pins, see Connectors on page 16.
3. Optionally connect an active speaker and/or external microphone.
4. Connect the cameras to the video inputs.
5. If powering the unit with AC or DC input, connect an external power supply. See note
below.
6. Check that the indicator LEDs indicate the correct conditions. For details, see LED
Indicators on page 15.
7. Insert a SD memory card if required and secure the SD memory card lid with the allen
key provided.
Note
• The unit can be powered using either the AC power, the DC power input, or PoE.
• If powering the unit using DC or AC power, connect the power supply to the power
connector at the rear of the unit.
• If powering the unit using PoE, connect a PoE network cable.
• To fulfill safety requirements, do not use AC power for outdoor installation.
• If using SFP, insert a 100Mbps/1Gbps SFP SerDes module to the SFP slot.
• The unit can only use one Network interface, either via SFP module or via RJ45 connector.
SFP module has higher priority than RJ45 connector.
AXIS Q7424-R Mk II Video Encoder
11