Bertolini 316 Bedienung Und Wartung Seite 48

CONTROLS (Fig. 2)
1) Motorstop
2) Clutch control lever
3) Differential lock lever
4) Left brake lever.
5) Right brake lever.
6) Handlebar height adjustment lever
7) Power Take-off lever
8) Gear control rod
9) Throttle lever
10) Handlebar horizontal adjustment lever
WITH ELECTRIC START
12) Start key
P = Stationery lights
0 = Voltage free circuits
1 = Voltage on circuits
2 = Start
13) Models with diesel engines
Low oil pressure indicator (yellow)
Models with petrol fuelled engines
Lights on indicator (green)
14) Low battery charge indicator (red)
15) Lights commutator
P) 12 Vcc feed headlight exit (not supplied)
ENGINE START-UP (Fig. 3)
When starting the engine, follow the
instructions contained in the engine's
"Use and Maintenance" booklet and,
after having made sure that the gear
control and P.T.O. control levers are in idle
position, lock the Motorstop lever 1 and clutch
lever 2 by using hook C. This prevents the
power transmission of engine with a gear
engaged.
N.B.: At each first start-up of the day, it is
BEST to let the engine run in idle position
for some minutes.
ENGAGING GEARS (Fig. 4)
The motorcultivators have a 5 -speed
gearbox (4 forward + 1 reverse) in both travel
directions.
- With handlebars in tilling position look at the
red symbols on the plate.
- With handlebars in front implements position
(mower bar) look at the yellow symbols on
Fig. 2
Fig. 3
Fig. 4
the plate.
To select speeds use lever8 (Fig. 2)
CAUTION: The engagement of the gears
should always be preceded by the
disengagement of the clutch. Avoid a
protracted clutch disengagement in order
to limit the wear of the thrust bearing.
The engagement of gears, when the
tools are mounted in front, must always
be preceded stopping of the machine
(stopping wheels) so as not to damage
the gearbox's gears.
46