Warranty - Chicco MiiNiMo 3 Bedienungsanleitung

HOW TO USE THE SAFETY HARNESS
This stroller has a five-point safety harness featuring two shoulder
straps, two adjustment holes, a waist strap and a crotch strap with
buckle.
6. WARNING: For use with children from birth to about 6 months, the
shoulder straps must be passed through the two horizontal adjust-
ment holes before use and the waist straps must be inserted in the
vertical holes (Fig. 6). After laying the child in the stroller, fasten the
belts by threading first the two forks inside the shoulder straps' slot
and then introduce them inside the crotch strap buckle (Fig. 6A);
adjust the length of the straps, ensuring that they adhere to the
child's shoulders and body correctly.
7. To unfasten the waist belt, press and pull the lateral forks (Fig. 7-7A).
WARNING: Always use the restraint systems. For the safety of your
child use all five fixing points of the safety harness belts.
Make sure to reassemble correctly the waist straps (e.g. after washing
) and the crotch strap, threading them through the holes located on
the backrest and on the seat. The harness must be re-adjusted.
ADJUSTING THE BACKREST
The backrest can be adjusted to 4 positions.
8. To lower the backrest, lift the adjusting handle located on the rear
of the backrest (Fig. 8).
9. To raise the backrest, simply lift it to the desired position (Fig. 9).
WARNING: The child's weight can make these operations more dif-
ficult.
REAR BRAKES
The rear wheels have linked brakes, which can be applied simultane-
ously on both rear wheels using one pedal only.
10. To operate the stroller's brakes, press downwards the pedal locat-
ed at the centre of the rear wheels axle (Fig. 10).
11. To release the brakes, push upwards the pedal located at the cen-
tre of the rear wheels axle (Fig. 11).
FRONT SWIVEL WHEELS
12. To make the wheels swivel, lift the lever found between the two
wheels (Fig. 12).
13. To lock the wheels, raise the lever (Fig. 13).
WARNING: Both front swivel wheels must always be locked or un-
locked at the same time.
WARNING: The swivel wheels make the stroller easier to handle; in
order to guarantee better stability, it is advisable to lock the wheels in
place on uneven ground (gravel, unpaved roads, etc.).
HOW TO ADJUST THE LEGREST
The stroller's legrest can be adjusted into 2 positions for your child's
improved comfort.
14. To adjust the legrest in the desired position, operate simultane-
ously the two side levers (Fig. 14). To raise the legrest up from the
down position, just pull it up.
CARRY-ALL BASKET
The storage basket is already installed.
15. In order to remove it, release the six snap buttons located on the
basket sides (3 per side) and extract the straps from the holes lo-
cated on the frame (Fig. 15).
RAIN COVER
16. To mount the rain cover, fully open the hood, wrap the velcro
around the stroller tubes in the positions shown in figure 16; re-
peat this operation on the other side.
When you have finished using the rain cover, allow it to dry properly
if it is wet.
WARNING: Use only the supplied rain cover.
WARNING: The rain cover cannot be used on the stroller without
hood, as it may cause suffocation.
WARNING: When the rain cover is fitted on the stroller, never leave it
exposed to direct sunlight with your child inside, as the temperature
will rise considerably.
FITTING AND REMOVING THE STROLLER LINING
17. to remove the lining from the frame, remove the hood following
the procedure shown in point 4 in the reverse order. To remove
the fabric part of the stroller, extract the side flap from the 3 plas-
tic pins located on the rear side of the handle tube (Fig. 17) on
both sides, then remove the two waist straps and the crotch strap
form the special holes located on the backrest and on the seat
(Fig. 17A-17B).
18. Release the fabric flap from the pin located under the seat (Fig. 18)
making sure to carry out the same operation also on the other side,
then complete the operation releasing the belt located under the
seat (Fig. 18A). Unhook the two side snap buttons (Fig. 18B) and re-
move the fabric from the pin (Fig.18C). At this point the fabric part
is released from the frame and can be extracted from the legrest
(Fig. 18D).
To complete the removal of the backrest fabric part, slide inwards the
plastic component positioned on the sides and pull the fabric part
upwards (Fig. 18E). The operation must be performed on both sides
of the backrest.
To reinstall the fabric part on the stroller, repeat the above procedure
in the reverse order, making sure to tension again the belt located
under the seat (Fig. 18A) at the end of the procedure.
FOLDING THE STROLLER
WARNING: When opening the stroller, ensure that your child and any
other children are at a safe distance.
WARNING: Make sure that during these operations the moving parts
of the stroller do not come into contact with your child.
WARNING: Before folding the stroller, make sure that the storage
basket is empty and the canopy is closed.
19. To close the stroller, push switch A to the left and simultaneous-
ly press the button B (Fig. 19). Rotate the handle forward until it
aligns with the side tube (19A) and push it down until it clicks into
place.
20. The stroller, once closed, stands by itself (Fig. 20A) and can be eas-
ily carried along by means of its useful carrying strap (Fig. 20B).
BUMPER BAR
The stroller is equipped with a bumper bar that can be folded when
closing.
21. To remove the bumper bar, press the two buttons on the side of
the bumper bar (fig. 21) and pull the bar towards you. To seat your
child in the stroller more easily it is possible to open just one side
of the bumper bar.
22. To fasten the bumper bar to the structure again, insert the two plas-
tic ends of the bumper bar in the supports as illustrated in Fig. 22.
WARNING: Always fasten your child with the safety harnesses. The
BUMPER bar IS NOT a device for containing your child.
WARNING: Never use the bumper bar to lift the stroller up with your
child sitting in it.
NOTE: On the Chicco Miinimo3 stroller it is possible to attach the fol-
lowing elements, which can be purchased separately:
• CHICCO soft carrycot
• KeyFit Car Seat
• Kaily Car Seat
• Kiros I-size Car Seat
All car seats for use on the stroller require the special adaptors sold
separately.
FOR THE ASSEMBLY AND/OR USE OF THE ITEMS LISTED ABOVE, REFER
TO THE RELEVANT MANUALS.

WARRANTY

The product is guaranteed against any conformity defect in normal
conditions of use as stated in the instructions. Therefore, the warranty
does not apply in the case of damage caused by improper use, wear
or accidental events. For the duration of warranty on conformity de-
fects, please refer to the specific provisions of national laws applicable
in the country of purchase, where provided.
13