Setting The Code; Directions For Use - Nederman 865 series Bedienungsanleitung

Setting the code

Only for remote controlled hose reel.
To allow the use of a number of reels in one location,
the reel must be coded. NB! Each reel must have its
To set another code:
1. Make sure the reel is con-
nected to the power supply.
2. Open the hand control and
set one of 8 possible codes.
3. Put the hand control together.
Then aim it against the reel's
indicator and push the SET-
button (minimum 7 s) The indicator
verfies by blue flasing light for
approximately 2 s.
Using the enclosed labels
(A B C), mark the hand control
and the reel with the same
code letter.
If more than 8 reels are to be used in the same room,
reels with the same code should be placed at least
10 m from each other to reduce the risk of interference.
Adjusting the limit positions for
coiled and uncoiled hose.
When delivered the reel has the limit positions adjusted
for the hose mounted on the reel. When needed the
limit positions can be adjusted again.
A reset of the limit positions then must be done in
the following way. Push the up- and down-buttons
on the hand control at the same time (10 s) until the
NB! Both limit positions must be
then the lower.
Adjusting the upper limit position
1. Push the up-button on the hand control.
Let the hose be moved to required upper
position. Release the button.
2. Push the up- and down-button at the
same time. The indicator is flashing blue
(8x) for a short time. The limit position has
now been adjusted.
Adjusting the lower limit position
1. Push the down-button on the hand
control. Let the hose be moved to required
lower position. Release the button.
2. Push the up- and down-button at the
same time. The indicator is flashing blue
(5x) for a short time. The limit position has
now been adjusted.
EXHAUST HOSE REEL
AB CA
AC A
BA B
BC C
10 s
Applications
Nederman Exhaust Reel is designed for stationary use
only and can, depending on hose diameter, be con-
nected to cars, trucks or other vehicles with
similar motor sizes.
for trucks: 800 - 2500 m
3
WARNING!
Risk of explosion!
The reel must not be used for other
purposes than exhaust extraction.

Directions for use

Operating the hose and fan
Aim the hand control towards the indicator of the hose
reel. The hand control will only operate the one reel
that has been correspondedly coded (remote control-
led reel only).
Push the down-button
• The fan starts at the upper limit for the hose.
• The hose moves downwards which is indica-
the required hose length has been coiled out.
WARNING!
Risk of severe personal injury.
• Check that there is enough suction in
the exhaust hose before it is connected to the
vehicle's exhaust pipe. If not, check the fan's
rotation direction and/or damper function. If
necessary check installation of fan start switch. •
An exhaust gas detector is recommended.
Push the up-button
• The hose moves upwards which is indicated
required upper hose position.
• The fan stops only at the upper limit for the hose.
Operating the fan
Short push on the down-button.
• The fan starts. Is indicated by fixed blue light.
Short push on the up-button.
blue light.
Stand by / power on
Is indicated by flashing blue light.
/h (470 - 1460 cfm)
blue
GB
9