Installation - Cognex In-Sight 7000 Series Handbuch

Installation

Installation procedures and specifications are presented in detail in the In-Sight
7000 Series Vision System Installation Manual, which is installed with In-Sight
Explorer software.
Note:
Cables are sold separately.
l
If any of the standard components appear to be missing or damaged,
l
immediately contact your Cognex Authorized Service Provider (ASP)
or Cognex Technical Support.
CAUTION: All cable connectors are "keyed" to fit the connectors on the vision
system; do not force the connections or damage may occur.
Install the Lens (C-Mount Lens
Configuration)
There are two lens configurations available for the vision system: an M12 lens
configuration, and a C-Mount lens configuration. If you purchased a vision system
with the M12 lens configuration, the vision system is shipped with the lens pre-
installed and no additional installation is required. If you purchased a vision system
with the C-Mount lens configuration, you will need to complete the following steps to
install the lens to the vision system.
6
®