Otto P 600 B-2 Bedienungsanleitung Seite 11

4.2.5
.1
D E B
4.2.5
.3
4.3 Cartridge refill (Mod 210 - 245* - 370* - 450)
(*) These models have a kit for conversion to cartridges.
Always disconnect the machine from the air supply when replacing the bag or at any other time when the front
ring nut is unscrewed from the tube, to avoid inadvertent pressure on the lever from causing sudden ejection of
the bag the crushing of fingers or any other risk for the operator and people nearby.
Always check the expiry date of all refill material used.
Never attach damaged or defective bags or cartridges to the gun.
Before disconnecting the air supply, press the control level to move the gun to the forward position, and never
remote the front ring nut during this procedure.
4.3.1
(*) For CSG II 245
4.3.3
(**) For CSG II 370
4.3.1 Move the piston forward to the end of the stroke, after which shut off the air supply, then turn the front ring nut (2)
anti-clockwise and remove it from the gun.
4.3.2 Use a 5 mm Allen key to unscrew the bag pressing cone anti-clockwise and remove it from the gun.
4.3.3 Cut the front part of the thread of the cartridge while avoiding damaging the thread behind it, turn the plastic nozzle
supplied clockwise with the cartridge attached, and then insert it on the gun the cartridge adaptor supplied (see exploded
drawings); the adaptor must be fitted fully down onto the central brass element, fitted with a rubber O-ring, to ensure
perfect airtight sealing; insert the cartridge onto the adaptor ensuring that the piston and adaptor are pushed fully down into
their seat.
4.3.4 Cut the front part of the thread of the cartridge while avoiding damaging the thread behind it, tighten the plastic nozzle
supplied clockwise with the cartridge on it, push the cartridge all the way in while pulling back the piston (CSG II 450), or
push up to the rear seal at the back of the tube ( CSG II 210 )
4.3.5 Turn the front ring nut clockwise until it exerts sufficient pressure onto the cartridge.
If the piston assembly tends to rotate, use a slotted screwdriver inserted in the spokes of the blue scraper to adjust.
4.4 Refitting the bag attachment (Mod 245 - 370)
4.4.1
4.4.3
4.4.6
C
2
**
A B C
4.2.5
.2
4.2.5
.4
to be provided by the operator
4.3.2
*
4.3.4
by the operator
4.4.2
*) For gun models CSG II 245
(**) For gun models CSG II 370
4.4.4/5
4.4.7
11
2
7
*
**
Manual CSG II Series - English