Helps & Hints - SIZZIX Big Shot PRO Anleitung

5. Helps & Hints
1. When cutting applique shapes, it is recommend to adhere the fusible adhesive
to the fabric before die cutting.
2. When cutting strips, place the folded edge of fabric on the top of die, making
sure the fold and selvage are inside the blade at the top and bottom of die. The
long edges of the fabric should slightly overlap the blades on both side.
3. When cutting delicate or thin materials, place a scrap of paper over the
material to be cut.
4. Using a higher quality material with a tighter weave will help avoid fraying and
provide the best results.
5. For your convenience, use dies with appropriately sized cutting pads.
See Die and Accessory Compatibility Table on page 15.
6. For easier cutting, place dies on Tray diagonally (not strip dies).
7. Use the Big Shot Pro Machine to cut a variety of different materials. See Materials
Guide on page 14 of suggestions.
8. Use of Premium Crease Pad is required with Crease-Rule dies.
9. Use only one sheet of material with Crease-Rule dies.
10. If crease rule is cutting through the material rather than creasing the mate-
rial, place the die and material to be cut on the Adapter Pad diagonally (as size
allows) and then cut.
11. It is important to use the Die Pick (included with the Big Shot Pro) to clean out
the bits of paper and other material that build up in the joints of the dies (where
the cutting rule meets). If dies are not kept clean, the scraps will eventually push
the rule slightly apart.
11