Using Sizzlits, Clearlits Or Decoetch Dies; Using Embossing Folders, Embosslits Or - SIZZIX Big Shot PRO Anleitung

Extended Sliding Tray
Using Sizzix Sizzlits
1. Place a Sizzlits Die onto a Standard Cutting Pad with foam side up. Place material
over the die. Place another Standard Cutting Pad over the paper or material to
create a "sandwich. " For a Clearlits Die, place die over photo or other material so
that the area to be cut shows through the die. Then place photo or material
and die between Standard Cutting Pads to make sandwich.
2. Place sandwich on Big Shot Pro Solo Platform and Solo Shim (sold separately)
and place on top of the Adapter Pad in the Sliding Tray (Figure E).
3. Follow Steps 3–5 in Operating Instructions, page 6.
Textured Impressions
Embossing Folder
Using Embossing Folders, Embosslits
1. With Simple Impressions Embossing Folder, Textured Impressions Embossing
Folder or Embosslits or DecoEmboss Die open, insert paper, foil or other
embossable material, then close like a book. Place Standard Cutting Pads
above and below the closed Folder to create a "sandwich. "
2. Place sandwich on Big Shot Pro Solo Platform and Solo Shim (sold separately)
(Figure F) and place on top of the Adapter Pad in the Sliding Tray.
3. Follow Steps 3–5 in Operating Instructions, page 6.
"Sandwich"
Figure E
® , Clearlits ™ or DecoEtch
Material
Figure F
8
™ Dies
Extended Cutting Pad
Textured Impressions
Embossing Folder
Extended Cutting Pad
Solo Shim
Solo Platform
Extended Adapter Pad
™ or DecoEmboss
Extended Cutting Pad
Paper
Die
Extended Cutting Pad
Solo Shim
Solo Platform
Extended Adapter Pad
™ Dies