Introduction; Machine Placement; Setting Up The Big Shot Pro Machine - SIZZIX Big Shot PRO Anleitung

1. Introduction

®
The Sizzix Big Shot
for full assembly and operation. The Big Shot Pro Machine will cut and emboss
a wide variety of materials with the entire line of Ellison
and embossing tools. See the Materials Guide (page 14) for specifics. When not in
use, place the dies in Sizzix and Ellison Storage Solutions (sold separately).

2. Machine Placement

Lift the Big Shot Pro Machine by its molded handholds at the ends of the
Machine. Place the machine on a clean, flat, sturdy, non-skid surface at a height
and position that are comfortable for the user. No part of the machine should
hang over the edge of the work surface.

3. Setting Up the Big Shot Pro Machine

Parts included:
Item:
( 1 ) Crank Handle
(2) Lock Washer
(3) Screw
(4) Screw Cap Cover
(5) Sliding Tray, Extended
(6) Cutting Pad, Extended
(7 ) Adapter Pad, Extended 1
( 1 ) Crank Handle (2) Lock Washer
(36.20cm x 31.12cm x 0.32cm)
™
Pro Machine package includes all tools and parts necessary
Qty:
1
1
1
1
1
2
(3) Screw
(6) Two Extended (7) Extended Adapter Pad
Cutting Pads
(36.20cm x 31.12cm x 0.50cm)
14 1/4" x 12 1/4" x 1/8"
®
, AllStar
Tools required:
3mm Allen Wrench (Included)
Die Pick (Included)
3mm Allen Wrench
(4) Screw Cap Cover
14 1/4" x 12 1/4" x 3/16"
4
®
and Sizzix dies
Die Pick
(5) Extended Sliding Tray
15 5/8" x 12 7/8" x 5/8"
(39.69cm x 32.70cm x 1.59cm)